Aiphone GF-HID Card Reader Panel

The GF-HID is an Access Control module for the GF Entrance Panel that contains an HID ProxPoint® Plus Card Reader. This module installs into the entrance panel and cosmetically matches, so a separate card reader does not need to be installed. The card reader provides electronic access to a building through the standard Access Control system, which is not supplied by Aiphone


Installation Instructions:


1. Install GF-HID card reader module in the GF entrance panel. (Install in a lower position for ease of access).
2. GF-HID will snap into the GF-2F or GF-3F frame.
3. Secure wire connections as shown on wiring chart.
4. Cut any unused wire so that bare wires are not exposed.
5. Refer to standard GF Installation Manual for complete system information.

Note: No additional information pertaining to the Access Control system is provided by Aiphone


Specs:

Power Source: 5.0 – 16.0 VDC
Absolute Max. Voltage: 18 VDC
Peak Current: 80 mA
Avg. Current 5V or 12V: 20 mA
Terminations: Color-coded pre-wired pigtails
Wiring Distance: 500'
Dimensions (H x W x D): 3 ¾” x 4 3/16" x 1 7/8"
Operating Temperature: -10° ~ 60° C / 14° ~ 140° F