X125 Two-Channel Amplifier (80/125W)Special OrderThe Russound X125 is a 2-channel dual source power amplifier with
auto-source switching. It features Primary and Secondary audio line
inputs with a loop out to another zone, receiver, or device from the
secondary source. A speaker-level input can be connected and assigned as
either the primary or secondary source. This amplifier can be used for
power upgrades in zones for large speaker selector or volume control
systems.
The X125 is rated at 125 watts per channel into 4 ohms,
and 80 watts into 8 ohms. With the Stereo/Bridge Mono switch in the
Bridge Mono position, both amplifier channels are combined for a higher
powered mono output. In Bridge mode the X125 is rated at 250 watts of
power into a single 8 ohm load. The 12V Trigger In/Out allows the
amplifier to be activated by other devices or to activate other
electronics via a 3.5 mm mini phone plug cable, with 100mA current
capability.
Features:
- Volume and balance allows for control at the component instead of volume control or keypad
- A/B speaker switching easily toggles output between two sets of speakers or zones
- Signal sensing inputs automatic turn on/off and switching to second source
- Bridgeable - delivers higher output for use with a subwoofer or outdoor speakers
Specs:Shipping Dimensions | 22.0" (W) x 5.3" (H) x 18.8" (D) (55.9 x 13.5 x 47.8 cm) |
Shipping Weight | 31.3 lbs (14.2 kg) |
Crosstalk | > 70dB @ 1 kHz, ref. to rated power @ 8 ohms |
Frequency Response | 20Hz to 20kHz +0.0dB/- 0.5dB @ 8 ohms, 1W |
Input Sensitivity | 500mV for 80W at 8 ohms |
Power Output | Continuous Stereo: 80W per channel at 8 ohms 125W per channel at 4 ohms
Bridged Mono: 250W bridged mono at 8 ohms |
Power Requirement(s) | 120VAC 60Hz 5.8A 230VAC 50Hz 3A IEC 320 type connector with 3 terminal detachable power cord. |
Signal to Noise Ratio | >93dB A-weighted |