SPECIAL ORDER NO ETA
Electronic Vibration Detector
Special Order
The EVD-1, Electronic Vibration Detector, is listed by Underwriters Laboratories, Inc. for primary protection of Mercantile or Bank, safe or vault, ATM machines and supplementary protection of interior units such as filing cabinets, display cases, walls and ceilings. The detector must be used with an appropriate UL listed control unit.
Note: The EVD-1 is a stand-alone detector. For applications requiring more than one detector, the EVD-2 may be more appropriate.
Features:
-
Detects all common threats to safes and vault
-
Sophisticated signal processing provides unprecedented sensitivity without false alarms
-
Low cost, stand alone system
-
Reliable, sensitive piezo sensor technology
-
Integral, multi-color status LED
-
Built in test circuit
-
Remote test and annunciator capabilities
-
Supervised microprocessor
-
Independent tamper output
-
On board test point facilitates installation and service
-
Built in accumulator
EVD-1 Controller
The EVD-1 controller detects short duration, large amplitude signals like those produced in attacks from explosions, hammering or chiseling. It also detects long duration, small amplitude signals like those produced in attacks from torches, thermic lances, drills, grinders or cutting discs. As soon as the EVD-1 detects a large amplitude alarm source it signals an alarm.
Specs:
Dimensions: 5.10"H x 3.26"W x 1.20"D
Weight: EVD-1 0.64 lbs.
Enclosure: Base: Die-cast aluminum
Cover: Stamped Steel, 22 Gauge
Power Input:
9.0 VDC to 16.0 VDC, 12 VDC Nominal, Maximum 0.1 V ripple
Note: If the EVD is going to be powered by the auxiliary power of a burglar panel, and the burglar panel has ground fault detection, it may be necessary to power the EVD from a separate UL listed 12 VDC power supply. Alternately, the safe may be insulated from ground.
Typical Current: (Supply Voltage 12.0 VDC)
Normal Standby Condition: 26 mA
Alarm Condition: 24 mA
Tamper Condition: 34 mA
With model RTA connected, add 10 mA in Tamper Condition and 10 mA in Alarm Condition.
Maximum Current: (Supply Voltage 16.0 VDC)
Normal Standby Condition: 26 mA
Alarm Condition: 24 mA
Tamper Condition: 34 mA
With model RTA connected, add 14 mA in Tamper Condition and 14 mA in Alarm Condition.
Contact Data:
Alarm Relay: Form C, 2.0 Amps at 30 VDC
Tamper Contact: Form A, 2.0 Amps at 30 VDC
