The ELK-110 Voice "Talking" Driver features high quality digitally
pre-recorded voice messages and loud attention getting siren sounds in
an economical, low current draw, compact package. It features two input
channels, bilingual voices (English and Spanish), and many unique
options which allow it to be used with virtually any residential or
commercial alarm installation. The voice messages and the siren
alternately sound whenever one of the channels are activated.
The ELK-110 may be customized by use of on-board jumpers. For example: the
MilliMiser™
option allows the already low current draw of the ELK-110 to be reduced
even lower. This is ideal for controls with limited alarm output power.
The
ComboTrigger™
option allows controls which have a single alarm output and pulsing
option to activate both the burglar and fire alarm sounds. The
VolumeStep™
option is best described as the "peacekeeper", since it causes the
siren sound to start at low volume, gradually increasing over 90 seconds
to maximum volume.
Features:• Installer Friendly - Compact & Easy to Mount
• Two Input Channels, Burglar & Fire
• Bilingual Voice - English and or Spanish, Siren Only, Speech Only, or Combined
• MilliMiser™ Lowers Current Draw
• ComboTrigger™ For Single Outputs
• VolumeStep™ Slowly Increases Siren Volume
• Temporal Coded Fire Signal
• Pre-Wired For Easy Installation
Specs:• Operating Voltage: 10 to 14 Volts DC
• Current Draw: 1.25 Amps, (800 mA on MilliMiser™ setting), with one 8 Ohm speaker
• Sound Level: 120 db @ 1 meter, 14 vdc, with one 8 Ohm speaker
• Max. Speaker Load: 4 Ohms
• Size: 2.75" x 4.0" (70mm x 102mm)