Call Toll Free 1-877-781-7178
or 1-732-583-7878

PayPal Logo
PayPal Acceptance Mark

Have you seen ...
Free shipping over $199
Shopping Cart:
now in your cart 0 items
Your cart is empty.
Free shipping over $199

System Sensor ST10 Metal Sampling Tube









Metal sampling tube, for duct widths 8' - 12'. For use with legacy duct smoke detector models, DH100, DH200, DH400 and DH500 series detectors

Special Order



Note: The sampling tube is identified by a series of air inlet holes on the tube. The sampling tube is always installed with the air inlet hole facing into the air flow. For duct widths greater than 18 inch, sampling tubes must be purchased separately. The recommended length is specified below. It is also recommended that the sampling tube length extend at least 2/3 across the duct width for optimal performance. Sampling tubes over 3ft long must be supported at the end opposite the duct smoke detector.

Outside Duct Width Sampling Tube Recommended*
1’ or less ST-1
1 to 2 ft. ST-1.5
2 to 4 ft. ST-3
4 to 8 ft. ST-5
8 to 12 ft. ST-10
*Must extend a minimum of 2/3 the duct width


Add to Cart:

  • Model: System Sensor ST10
  • 0 Units in Stock
  • Manufactured by: System Sensor

Parse Time: 0.309 - Number of Queries: 246 - Query Time: 0.15311545059204