UltraProx Wiegand Reader The Elk-106055 UltraProx Wiegand Reader is a compact, technically advanced external proximity reader with 26 bit Wiegand output for use with a separate controller. Compatible with Elk M1 control panels and most other access controllers. Ideal for higher security installations and as an alternative to remembering PIN codes. Features: * Compatible with ELK M1 controllers (use ELK-W035A wiring...
M1 Data Bus Hub For easy connection of expanders & keypads. The M1DBH accepts up to 9, RJ45 equipped CAT5 or CAT6 cables, and series connects the data A & B lines so the data bus may be terminated properly. Two or more units may be interconnected if more than 9 data lines are required. Features: • Designed For Multiple Home Run Cables • Internally Connects Data A & B Lines From Previous Device In to...
M1 Data Bus Hub For Retrofit An "active" RS-485 data bus hub designed for jobs where an M1Gold or M1EZ8 Control is retrofitting an older panel that has multiple homerun 4 conductor keypad/data wires. It splits the main 485 data bus into 4 managed 485 branches. Each branch can have 2 parallel home run cables for a total of 8 home runs. The end of each cable is EOL...
Main Serial Interface Special Order The ELK-M1EZ8MSI Main Serial Port Interface allows direct RS-232 Serial Communications to an M1EZ8 Control for Upload/Download programming, and for interfacing with other Computer type devices. Also required when adding the M1XEP Ethernet Port to an M1EZ8 Control. The speed of this port is software selectable from 300 to 115,200 baud. Features: • Adds A High Speed...
Two Way Listen-In Interface Special Order Adds up to three (3) zones of two way listen-in to M1 Gold Control. This can be used by the Central Station to verify an alarm. Up to 12 microphones (M1TWS) may be connected. Features: • Requires ELK-M1TWM or M1TWS Microphones • Operating Voltage: 12 Volts D.C. • Speaker (Output) Load: 2 to 16 Ohms • Current Draw: 50mA to 80mA (depending on load and volume setting)...